My way of dealing with gun corrosion

It is known that due to the action of dew, rain, and snow, the gun is corroded. It rusts especially strongly when it is affected by sea fog or sea water. Chrome-plated barrel channels, modern domestic oxidation, and their surfaces are not afraid of corrosion, but imported guns, especially German ones, rust even through oxidation. An old gun with worn-out oxidation spots becomes covered with a red coating, even when it is worn while hunting.


It's easy to avoid rusting. I do it this way.


I take a hot (so that my hand can only tolerate) saturated baking soda solution and wash off the gun oil from the outer surface of the barrels and from all fixed metal parts of the locking mechanism of the forearm and trigger guard. Then I wash all these parts with hot water. If water is rolling down from any place, it means that there is still oil here and it must be washed with a cloth soaked in soda solution until the water stops rolling down.


After that, I pour boiling water into a vessel, pull a cloth over the ramrod so that it fits tightly but not tightly into the trunks, lower them into hot water and rinse with boiling water, moving the ramrod up and down until the trunks are evenly heated along their entire length. Heat the water to 60-80 ° C. At the same time, trunks and other metal parts should not be taken with bare hands, as they leave grease spots on the metal. To prevent this from happening, the trunks are covered with a clean cotton cloth or a washed canvas glove is put on the hand.


After heating the barrels, I insert some kind of stick tightly into the chamber, which. it would be possible to hold the trunks without touching their surface. Then I make a swab out of a soft cotton cloth, dip it into the VF-2 glue and run the swab non-stop from one end of the trunks to the other. If the tampon is not stopped anywhere and carefully carried out strip by strip along the entire length of the trunks, then the coating will be smooth, and the adhesive layer will be very thin and transparent. Since the barrels are hot, the glue dries instantly.


You cannot stop the tampon anywhere on the trunks without extending it to the end of the trunks. Otherwise, the glue in this place will remain lumps and spots; it is difficult to remove it from the trunks. This is how I cover all the other parts of the gun, with the only difference being that I heat them not with boiling water, but over a stove, in an oven, or over an electric stove. I use a stiff oil paint brush to cover hard-to-reach places and small details.


When all the parts are covered with glue, I lubricate the gun with gun oil and assemble it. After that, I also lubricate the joints of the metal parts with wooden ones (handguards and boxes with a block) several times with glue and dry them so that water does not get into the gun and its mechanisms at the joints. The glue in these places does not crack from the shot and holds firmly, but it does not interfere with the disassembly of the gun.


After the glue has dried at the joints, the gun can be lubricated externally with gun oil; it is ready for use or storage under normal conditions. The glue is not afraid of gun grease.


Such a cover is enough for one or two hunting seasons or more. The glue wears off mainly in places adjacent to the hunter's clothes from friction when walking. In this case, the coating process should be repeated.


When preparing for a new coating, you can remove the remaining glue with ebonite, getinax, textolite or other similar materials. They should act the way they do when they polish a wooden surface with a piece of glass. I have been using this coating for three years now and during this time I have restored the coating only twice. There has never been a case of even a small rust coating on the gun, although I hunt in very difficult conditions on the Kuril Islands. अगर आप ऑनलाइन कैसिनो खेलना चाहते हैं बिना किसी जमा राशि के, तो free 100 sign up bonus no deposit india का लाभ उठाएं। Holy Moly कैसीनो वेबसाइट आपको भारत के टॉप कैसिनो के बेहतरीन बोनस ऑफ़र और मुफ्त में गेम शुरू करने के अवसर प्रदान करती है। आज ही जुड़ें और तुरंत खेलना शुरू करें!